I had some time today and wanted to get out of the city here in Tampa so I went to Little Manatee River State Park and setup a quick little activation on 15 meters.
This park is really nice and well cared for. It has many hiking trails as well as a creek on one side that you can canoe in…just dont pet the alligators and you will be fine there, but they do have an equestrian area as well. Plenty to do if you want to do something other than park activations for some reason…lol
Today saw me setup on the bed cover agian as it was nice out and I was mostly in the shade so I knew I wouldnt get too hot. I ran CW only as I didn’t feel like messing with the sBitx V3 to work FT8 as I really only had about 30 minutes of operating time and for me, the FT8 contacts come in a little slower than the CW contacts. I did choose 15 meters though which was a little bit of a gamble, but it worked out once I got on the air and tuned around the band a little and found it was active, I rested a little easier.
I ran the Ten Tec Argonaut 5 transceiver today with the N3ZN key and Hamgadgets memory keyer. This radio is a joy to use for CW and I really enjoy using it for park activations. It has about 20 watts full output, but today I was only running 15 watts as I normally don’t push the old transistors as hard as when they are new… probably don’t matter, but in my mind it makes sense. When I am operating, I use 3 things, well 4 if you count the AF gain (volume). I use the multi-function knob to control the BW (band width of the filter) and the RIT control. The same knob does both jobs, you just hit which ever button you need first then set that function to what you want. The display is currently showing the BW setting of 600 Hz. I will open it up if the band is quiet, but this thing is pretty selective and will allow me to go down to 250 or 300 Hz if I need it and works really well.
Today also saw the use of zero radials. I wanted to see what the SWR would be without anything since these antennae are designed to be used without a counterpoise and just work off the coax shield and car body. I was pleasantly surprised when the nanoVNA showed 1.3 to 1 right out of the chute! Seems my antenna for the band is tuned a little low like this. If I add the 20 meter radials it balances better and move the frequency up closer to where I operate and gets that super deep null right on me.
I did experiment a little with how I laid out the coax to see what it would do and the result was minimal to say anything. I think I changed the reading by .01 SWR from start to finish. Totally not worth the extra effort to optimize the coax… The photo below shows me pointing at the best setup I found and the screen of the VNA showing my target frequency on a 4Mhz slice of spectrum.
I had problems with RF in my keyline. I am guessing due to the proximity of my key and keyer to the antenna. With electronic keying, rf can trigger the keying circuit adding unwanted dots and dashes to your code. I solved this by adding rf chokes to literally everything. If you will notice they are on the key cable as well as the keyer to radio cable and I still have that huge one on the coax as well. I have not added them to the power cables yet but might to see if it will help.
At the end of the day, all POTA is good POTA and I had a wonderful time working a ton of stations. The Ten Tec Argonaut 5 is a great little radio and I count my blessing for being able to land one for reasonable money. If you are a CW guy, then I suggest you try some of the Ten Tec radios as they are simply sublime machines for this mody. I quickly became an addict of their radios and will continue to be for many years to come. Thanks and I hope you get on the air and have some fun soon!
73 - WK4DS