I don’t know if you have a favorite radio or not, but I do. The Ten Tec Argonaut V is one of my all time favorite portable CW rigs and for good reason! This radio brings all that is CW and Ten Tec together in the perfect combination of fun and ease of use.
Of course, this radio also has several other modes (although I could not tell you all of them as I have never switched it off of CW) but it will do other modes as well. All that said, it is a wonderful little CW machine and the ergonomics for use with CW show through in the design of the radio. From the minimalist layout to the proper location of critical operating controls, this radio is just about perfect. The only other thing that would make this radio even better would be the inclusion of Collins mechanical filters in the IF..but I digress… (Giving a quick nod to my Omni 7).
You see, when you’re activating a park with a small CW radio, you only need a few controls to be able to work the contacts coming in. The main two being the RIT for stations that are off your beat frequency by more than is comfortable (I had one of these today) and the filter bandwidth adjustment. These are the same knob on the Argonaut 5 and it is a simple button press to switch between these two functions. Another point to consider is these buttons are grouped near each other too so you are not searching all over the radio for the controls you need to work your activation. Along with these two controls the only other one I use while activating is the volume to bring down strong signals and it is also right next to the other controls, keeping the process really clean for me. Honestly the radio seems to be laid out with the “set-n-forget” stuff on the left side and the “active-use-while-operating” controls on the right now that I look at it.
Enough of me gushing on about the radio, we all know that I love this little machine…So onto the key and keyer. The key is my N3ZN travel key and it is fed into a HamGadgets Picokeyer both which are wonderful devices and work exceedingly well with the Ten Tec Argonaut V amateur radio. It has been a while since I have used the Hamgadgets Picokeyer so I had to get out the owners manual to see how to change one of the settings. Taking copies of the manuals is something I am a huge proponent of as it just makes sense. Without this book I would have been searching online, and sometimes that is not available at a park. The paper book never has a “dead battery” and is always ready to serve you. Take copies of the books with you…
A good cup of coffee is crucial to a good activation!
I went to my old haunt today US-2169 to get on the air and work some CW contacts as the space weather showed that the sun was still being friendly. I get to the park and find that it is starting to rain so I hurriedly setup my hamstick for 20 meters (I didn’t want to change bands alot with it raining…) and threw some electrical tape on the coax connector for a temporary rain jacket and got back in the truck. Pro-tip about electrical tape, turn it around backwards with the sticky side out and twist the end of the tape so it is easy to grab and unwind later if you don’t want the adhesive sticking to your parts. Things like the putting it on the coax connector as a temporarily rain shield is the perfect application for this idea. When you are done just unwind the tape and put it in the trash.
I had setup a new radial field design today as an experiment to see if adding a really long radial would work (or even help) and was pleasantly surprised to find it did! I really love using the nanoVNA to measure my antenna instead of a simple SWR meter, even though today I used the SWR function instead of the smith chart.
The power of the smith chart can not be overstated either. What you get to see on the smith chart is the data that the SWR plot shows (well, it shows the impedance and you have to know a little math to turn it into SWR) and is also shows you if your system is capacitive, inductive or purely resistive (the best option if you get to pick). Now this doesn’t mean your signal is going to get out to some distant DX station super well just because the SWR is 1:1, but your transceiver wont have to deal with reflected signals coming back down the line out of phase with the transmitted signal. I was a ham for way to long before I learned the power of the smith chart…and I have just scratched the surface of what can be done with it. All that to say that 1.061:1 is a great SWR for a field deployed antenna…lol
Just for fun I decided to look and see what the SSB segment would be since I tuned this antenna to center frequency on the CW portion and it is still good in this configuration. Dont let any SWR reading below 2:1 scare you, all radios are designed to be able to work into at least that much SWR as EEs (Electrical Engineers - the guys who actually design radios) know that these devices are going to end up in not-so-perfect applications and want them to work anyway.
The measurements, roughly, for these radials are 14’6” and 26’ respectively and they are laid out with the shorter one being 90 degrees to the truck. This is the position that I tuned the antenna at, with this radial as well as it’s mate running out the other side 180 degrees out from this one.
The 26’ radial is run pretty much away from the truck to the rear and it gets the benefit of running down the slope too. This angle adjusts the impedance of the antenna by changing the reactance. This is why discone antennas have the ground plane at 45 degrees sloping down, it presents a near perfect impedance to the transceiver. I will repeat this setup on my next trip and put the smith chart on it to see what it says about the system, I am curious to know now…
I keep this Ultra Picokeyer from Hamgadgets and the N3ZN portable CW key with the Argonaut V so every time I use this radio, I will have a memory keyer and nice paddle to operate it with. It had been a hot minute since I had used the Ultra Picokeyer so I needed to get the manual out for it. Seems for some reason last time I used it, I had enabled the internal tone (for use as a practice oscillator) and wanted to silence it for the activation. I knew how to get into the menu, but I didn’t remember the item name specifically, so out comes the book…
I can not stress how important it is to me to have the manuals to the devices I am using, stored with the kit. The only exception is when the device is so simple and intuitive that you don’t need one anyway (like with the Penntek TR-35 transceiver). So I keep home-made copies of manuals to both the Ultra Picokeyer and the Ten Tec Argonaut V transceiver in the hard shell case with them. They have saved me a couple of times already. Me and my friend KG4WBI (Roger) have this obsession with printing the manuals and then building them into these term paper booklets so we will have them later, I have so many manuals at this point, I have manuals for radios I no longer own…lol.
The 20 meter band was actually really good today. There is supposed to be significant solar problems right now as a problematic sunspot is pointing our way but I was graced with a little time to get on the air and was greeted with quite a few hunters to my surprise! As you can see in the beacon report below I was getting into New Hampshire quite well!
Some observations from today that I noticed were that I was getting states that I shouldn’t have been hearing… States like Alabama, North Carolina and even GEORGIA! I don’t ever get this kind of NVIS operation on 20 meters, I usually have to go to 40 meters to see this sort of thing happen.
Another thing was I was getting some pretty heavy QSB (fading of the signal) at times as well. The QSB even seemed to come and go which was normal to be honest for this sort of thing, but what made it unusual for me today was how deep it was. 599 signals would just disappear for 2 seconds the fade back in. Deep…
Fortunately I was able to get all the information for my log. There was a significant amount of US ops only on this day too. I figured there would be a few more Canadians as well but I only worked one on this day . It is always great to get some of our friends to the North in the log.
The diversity in the log spread today can not be understated. I was blown away with all those southern states coming back to me. Strange conditions for sure, maybe the new radial idea improved NVIS, maybe they have always been able to hear me and when I would activate there just wasn’t anyone hunting… I don’t know, but today they were there and I was stoked! Thanks for coming along and I hope to see you in the comments below.
WK4DS